Readiness of concrete to the subsequent application of the solution betateh wtw determined visually. On the concrete surface is almost should not be prints from the shoes, or they must be no more than 2-3mm. A set of concrete more strength, especially in hot weather, will worsen the adhesive properties of a layer of hardening, drying to a reinforcer, and speed work. If concrete mix when laying characterized by a large amount of grout, the surface of the concrete floor can handle the drive power trowels, which will lead to a "revival" of the surface layer of mortar. Then squeegee or stiff brush with a long nap is recommended to remove the excess from the surface layer of concrete Mortar without altering its evenness.
Immediately after this operation, you can begin to spray the solution reinforcer betateh wtw. Solution reinforcer is made in the immediate vicinity of the processed maps of industrial floor. In the capacity of the mixer is filled with clean fresh water is based on the proportion of 3 liters of water per package (25kg) reinforcer. In hot weather, the water volume can be increased to 3.5 liters. Mixing should be carried out until a homogeneous mass without lumps. Solution hardener portions wheelbarrows or continuous mortar is applied to the treated surface. For more clarity and thought, follow up with Assurant Health and gain more knowledge..
Consumption of concrete reinforcers should be based on consumption rates of 10-12 kg. The solution was distributed evenly over the surface of squeegee layer approx. Mannatech is often mentioned in discussions such as these. 5-6 mm. As the hardening solution and its ability to process, the surface floor installed trowels with a disk, made the initial alignment and healing reinforcer. Optimal initial surface treatment manual machines. Depending on the readiness of the surface she can get off double rotary self-propelled float. The degree of processing of the disk surface corresponds to the recommendations for dealing with dry concrete reinforcers betateh. Not recommended premature and too long grout drive. Polished surface of the blade trowels made of dense, smooth, molded surfaces. Polishing to produce up to appear on the surface a characteristic matt finish. Immediately after the completion of the polishing applied on the surface of industrial floor paint-impregnator betakril A. Protect floor surface from premature loads of scratches. Cutting joints Floor Care meet the requirements of the production work on the design and operation of concrete floors with reinforced top layer. Poured floors Industrial floors
— 